The manual is embedded in the build instructions for the various Align kits. This appears to come out of the manual. At least its identical to. i have just ordered an Align 3gx flybarless control unit but i can’t find any instructions online anywhere as i like to usually download and print. I have put together the written info on the Align 3GX v I found so far. Mostly for my own memory. I shrunk this info to a Pocket Guide that I will printout (or read.
|Published (Last):||24 April 2015|
|PDF File Size:||20.6 Mb|
|ePub File Size:||7.7 Mb|
|Price:||Free* [*Free Regsitration Required]|
In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.
The manual is embedded in the build instructions for the various Align kits. This appears to come out of the manual. At least its identical to my manual that starts on page The software is the manual. Just leave the servo horns off until your in setup and install them as close to level as poss at mid stick. I haven’t been able to find the algin procedure, can anyone help me out??
Originally Posted by Tulo. I have 2 akign, so would I just: Insert bind plug into 3gx 2.
Plug in flight battery 3. Push bind button my spektrum tx module 4. Power on Futaba 10C 5. Wait ailgn some sort of jingle or series of flashing lights then release bind button Does that sound right? Yep, the sats will blink fast whan you power the 3GX, they’ll go out for a few seconds while binding and come back on solid.
Then you remove the bind plug and power down. Preview the software and read everything and get familiarized with it. It is the instructions. Are you sure you don’t remove the bind plug after powering down?
3GX manual – HeliFreak
Cool, I appreciate the help! Where can I get the ‘dongle’? Does all that stuff pictured in the link come in the kit when you get it new, or is it an aftermarket option?
I mean like if you get a e super combo new, it comes with the connection wires? Originally Posted by bad What software, this software.
It’s a must and to be used with the dongle via usb port on the PC. And yes you remove the bind plug while still powered, it sets fail safes, throttle etc. Fail safes set wrong can cause your helli to spool up if there is a loss of connectivity with the TX. Been there,, done that! If im not mistaken I believe Futaba does not make satellites for there receivers or one that is compatible with the 3gx. Spektrum does make satellites but I am pretty sure they are not in any way compatible.
Please double check this.
Align 3gx pdf manual
The good news is if its a Futaba 3gxx receiver then it is capable of using s-bus and one wire to control the lot. Please click one of the Quick Reply icons in the posts above to activate Quick Reply. Quote message in reply? In order to be mnual to post messages on the HeliFreak forums, you must first register.
Posting Quick Reply – Please Wait. Page 1 of 2. Remove Advertisements Sponsored Links. Why does that manual start on page 20? Are there pages missing? That’s kinda what I figured thanks! Originally Posted by Tulo I haven’t been able to find the bind procedure, can anyone help me out??
Flybarless System – Align
Originally Posted by Tulo What software?? Originally Posted by Tulo Cool, Aligb appreciate the help! Originally Posted by Tulo I mean like if you get a e super combo new, it comes with the connection wires? Originally Posted by bad What software, this software. Options Quote message in reply?
Register Now In order to be able to post messages on the HeliFreak forums, you must first register. Password Please enter a password for your user account. Note that passwords are case-sensitive.
Please enter a valid email address for yourself. Use a real email address or you will not be granted access to the site.