Hallu®-Fix Arthrodesis System. CLOSE. Home > Orthopedics > Foot & Ankle > Hallu®-Fix Arthrodesis System. Hallu®-Fix Arthrodesis System. ×. Hallu®-Fix. The HALLU®-Lock M.T.P. Arthrodesis Plating System is intended for fixation of The HALLU-Lock plates must be fixed with the Surfix® fixed angle locking. HALLU®- FIX, HALLU®- LOCK & Total Foot System Metatarsophalangeal. (MTP) Joint Arthrodesis System Reimbursement Guide – Effective October 1.
|Genre:||Health and Food|
|Published (Last):||1 February 2007|
|PDF File Size:||6.17 Mb|
|ePub File Size:||10.24 Mb|
|Price:||Free* [*Free Regsitration Required]|
Universal system Modular packaging maximizes screw options Low-profile design More information. Locking of the System Step Operative Technique 4 Antegrade More information. The cup shaped surfaces can be aligned in any desired position.
A Hohman retractor usually helps to expose the phalanx.
Any reproduction of the present publication is prohibited in whole or in part and by More information. Care is taken not to penetrate the interphalangeal joint. Read the indicated screw length directly from the scale fig.
Designed to provide stable internal fixation. It is a minimally invasive procedure More information. Fractures of the wrist The wrist joint is made up of the two bones in your More information. This documentation is intended exclusively for physicians and is not intended for laypersons. Drill Bits for Screw Removal.
Integra Hallu-Fix | LMT Surgical
For intramedullary reaming and bone harvesting. Information on the More information. Medial exostosis of the 1st ifx bone may also be resected. The metatarsal metaphysis is reduced to a cylinder of constant diameter, while the metatarsal head surface is reamed to a convex cup-shaped surface. Drill into stainless steel, instrument steel, or titanium Remove locking screws Single use, sterile-packed Drill Bits Intended use High speed.
The Locking screw on the head of the screw should block the hole of the plate remaining parallel to the plate the screw is maintained in an oblique position. The metatarsal head should be protected when reaming. Torx screwdriver and AO torx screwdriver tip Fractures of the Wrist and Hand: Chamfering of the Hole Step The small central hole should be positioned over the center of the metatarsal head.
Surfix drilling guides For Mono-Cortical fixation subtract 1. For axial stabilization and simultaneous protection of soft tissue.
Instruments for removing Synthes screws.
Hallu-Fix MTP Arthrodesis System
Carpal Tunnel Ligament Release. Rauh, MD The opinions expressed are those of Dr. Aesculap Spine S 4 Cervical System. Compression Device Step Haklu screwdriver ND can be used for both locking and non-locking screws. Plate Selection More information. Page 4 Design Features If necessary, due to the diameter of the articular surface of the phalanx, superior sizes of the phalangeal reamers can be used until the dimensions match the size used for the metatarsal reamer.
A temporary K-wire is introduced from the phalanx to haplu metatarsal to stabilize the joint in the adequate position for final arthrodesis. Positioning of the Locking Screw Step Instruments and implants approved by the AO Foundation.