ICC ANSL A117.1-2003 PDF

Trademarks: “ICC,” the International Code Council logo and “Accessible and Usable Buildings and Facilities (ICC/ANSI Al )” are trademarks of the. This Accessible and Usable Buildings and Facilities (ICC Al) is a The edition of ANSI Standard A presented the first criteria for accessibil. Major changes/additions from ICC ANSI A – found in the edition of A 1. ICC ANSI. A – Section. ICC ANSI A –

Author: Tauzahn Sak
Country: Sweden
Language: English (Spanish)
Genre: Environment
Published (Last): 6 November 2004
Pages: 254
PDF File Size: 11.78 Mb
ePub File Size: 20.16 Mb
ISBN: 135-3-65662-695-3
Downloads: 57356
Price: Free* [*Free Regsitration Required]
Uploader: Mikarg

Accessible Routes width of the landing shall be at least as wide as the curb ramp, excluding flared sides, leading to the landing. Continuous handrails at the inside turn of stairs and ramps.

Table of Contents | ICC/ANSI A – | ICC premiumACCESS

Nosings that project beyond risers shall have the underside of the leading edge curved or bev- eled. A vertical grab bar 18 inches mm minimum in length shall be kcc on the control end wall 3 inches 75 mm minimum to 6 inches mm maximum above the horizontal grab bar, and 4 inches mm maximum inward from the front edge of the bathtub. Terms specifically defined in a referenced standard, and not defined in this section, shall have the speci- fied meaning from the referenced standard.

Verbal annunciators shall have a frequency of Hz minimum and 3, Hz maximum. Braille dots shall have a domed or rounded shape and shall comply with Table In alterations, full extensions of handrails shall not be required where such exten- sions would be hazardous due to plan con- figuration.

ICC/ANSI A – Accessible and Useable Buildings and Facilities

Door closers shall be adjusted so that from an open position of 90 iicc, the time required to move the door to an open position of 12 degrees shall be 5 seconds minimum.

A hori- zontal grab bar 24 inches mm mini- mum in length shall be provided on iccc control end wall beginning near the front edge of the bathtub and extend toward the inside corner of the bathtub. Grab bars shall be installed in a horizontal position, 33 inches mm minimum and 36 inches a171.1-2003 maximum a117.1-20033 the floor measured to the top of the gripping surface.

Where provided, curb ramp flares shall not be steeper than li: Where specific criteria of this stan- dard differ from the general criteria of this standard, the specific criteria shall apply.

  DARURILE IMPERFECTIUNII PDF

The telephone handset cord shall be 29 inches mm minimum in length. Detectable warning surfaces shall contrast visually with adjacent surfaces, either light-on-dark or dark-on-light.

Elevator, car controls shall comply with Section Protruding objects shall not reduce the clear width required for accessi- ble routes. A swing-up grab bar shall be installed with the centerline of the grab bar 15?

August Fifth Printing: A short ramp cutting through a curb or built up to it. Doors and sidelites adja- cent to doors containing one or more glazing panels that permit viewing through the panels shall have the bottom of at least one panel on either the door or an adjacent sidelite 43 inches mm maximum above the floor.

2003 ICC Accessible and Usable Buildings and Facilities

Clear opening width of doorways with swinging doors shall be measured between the face of door and kcc, with the door open 90 degrees. Transfer-type shower compartments shall have a clear inside dimension of 36 inches mm in width and 36 inches mm in depth, measured at the center point of opposing sides.

At the top of a stair flight, handrails shall extend horizontally above the. A hand shower with a hose 59 inches mm minimum in length, that can be used both as a fixed shower qnsl and as a hand shower, shall be provided.

You may delete a document from your Alert Profile at any time. The number five key shall have a single raised dot. Handrails shall be at a consistent height above stair nosings, ramp surfaces and walking surfaces. Proposals for revising this edi- tion are welcome.

Swinging doors shall have maneuvering clearances comply- ing with Table Substantial agreement means much more than a simple majority, but not necessarily unanim- ity. Without advance written permissionfrom the copyright owner, no part of this book may be reproduced, distributed, or transmitted in any form or by any means, including, without limitation, electronic, optical or mechanical means by way of example, and not limitation, photocopying, or recording by or in an information storage retrieval system.

Cic end of the “L” shall be 22 inches mm minimum and 23 inches mm maximum from the main seat wall. Operable parts shall a117.1-200 placed within one or more of the reach ranges specified in Section Car parking spaces shall be 96 inches mm minimum in width. Controls shall be on a sidewall, 12 inches mm minimum from any adjacent wall. The intent of this standard is to allow a person with physical disability to independently get to, enter, and use a site, facility, building, or element.

  GENIUS TYMPANIC THERMOMETER PDF

Toe clearance at the side partition is not required in a compartment greater than 66 inches mm in width. Alternate roll-in shower compart- ments shall have a clear inside dimension of 60 inches mm minimum in width, and 36 inches 91 5 mm in depth, measured at the cen- ter point of opposing sides. Accessible Routes Chapter 4. Risers shall be 4 inches 1 00 mm mini- mum and 7 inches mm maximum in height.

In existing elevators, where a new car operating panel complying with Section Where a forward reach is unobstructed, the high forward reach shall be 48 inches Where enhanced reach range is required at lavato- ries, faucets and soap dispenser controls shall have a reach depth of 11 inches mm maximum or, if automatic, shall be activated within a reach depth of 1 1 inches mm maximum. Operable parts, including doors, lint screens, detergent and bleach compart- ments, shall comply nasl Section Where detectable warnings are provided on curb ramps or at raised marked crossings leading to islands or cut-through medi- ans, the island or cut-through median shall also be provided with detectable warnings complying with Sectionare 24 inches mm in depth, and extend the full width of the pedestrian route or cut-through.

Van parking spaces that are angled shall have access aisles located on the passenger side of the parking space. The high forward cic shall be 48 inches mm maximum where the reach depth is 20 inches mm maximum.

Destination-oriented elevators shall be permitted to have signals visible from the floor area adjacent to the hoistway entrance. Access aisles serving car and van parking spaces shall be 60 inches mm minimum in width.

Each curb ramp shall have a level area 48 inches mm minimum in length and 36 inches mm minimum in width at the top of the curb ramp in the part of the island intersected by the crossings.